|
|
No E-Bay Auctions
at this time |
|
|
|
|
|
|
Refer
a Friend
Please
|
|
|
|
|
K0D8-D Decoder Installation for Drop-In
If you are looking for something specific, not shown below,
please use
the
Google Search Link
here,
or the Google search at the bottom of all pages on our site:
If you are
unable to find an item on our site after using the Google
search,
e-mail us and let us know what item you could not locate.
|
Stock
Items!
As much as possible and within the limits of demand
and responsible fiscal management we keep these in
stock |
|
TCS Kato K0D8-D Decoder for EMD F3B
The following pictures are detailed instructions on how to install the K0D8-D decoder as a drop-in into the EMD F3B Kato Locomotive
|
The TCS1/4" Kapton tape used in this installation is not supplied with the decoder and needs to be purchased separatly at your local TCS dealer. Please inquire with your order via email.
Click
on ANY picture to see full size photo
The picture above shows the Kato EMD F3B unit prior to the K0D8-D decoder installation.
Gently, remove the shell from the chassis as shown above.
Here is a picture of the locomotive chassis after the shell removal where you can see the original light board.
Remove the black, plastic interior part.
The gray plastic clip (marked in red) holds the original light board and motor tabs in place.Gently, remove the plastic gray clip by pulling it up.
Gently, spread two (marked in red) motor tabs. Be very careful not to break them!!!!
Remove the original light board.
Gently, remove the power pick-up copper rails as shown in the picture above. Be very careful not to bend these rails because they are very delicate and can easily break.
Use a small piece of Kapton tape around the track power pick-up rail (marked in red) so that it is isolated from the motor tab. This is a very important step of the installation and ignoring it might damage the decoder!!!!!
When inserting power pick-up rails makes sure you insert them the way upper pictures shows.You have to stick to the same method on both ends.
The picture above shows properly done isolation of both motor tabs.
Gently, place the TCS decoder on the chassis as shown in the picture above. Make sure you place the decoder so that both motor tabs are fully alligned with the decoder square copper pads.
Very gently, push motor pick-up tabs down so that they touch the copper pads of the decoder. Be very careful not to break the delicate copper tabs.
Insert the gray plastic clip that was removed on the beginning of this installation. The clip holds motor pick-up tabs down so that the electrical connection is possible.
If for any reason there is a problem with the connection we suggest using small amount of solder to connect the motor tabs with the decoder (see picture below). Tint the copper pads with a little amount of solder and than solder motor tabs to the decoder.
Here is the picture of finished installation of TCS K0D8-D decoder. When run at speed step one you can see outstanding slow speed performance of this 8 function TCS decoder that is equipped with Back EMF.
|
Last Update:
Friday, April 2, 2010 12:02 PM
, By JF
|
|
|